A new development of equal channel angular pressing method to fabricate wire-formed samples has been proposed and experimented. In this approach, wire-formed specimen, which is inserted inside a polyurethane rubber pad material, has been pressed using conventional equal channel angular pressing die. Commercial pure copper samples in the shape of wire have been equal channel angular pressed up to 12 passes by route B_C, and then hardness behavior, electrical conductivity and microstructure observation of deformed samples have been examined. The results indicate that about 77% and 66% enhancements at the hardness value (HV) magnitudes have been obtained after 8th and 12th passes, respectively, as compared to the unequal channel angular pressed state. Reductions of about 92% and 95% at the grain size of pure copper have been observed after 8th and 12th passes, respectively, in comparison with the annealed condition. Also, the first pass of equal channel angular pressed wire has both the worst hardness distribution homogeneity and the lowest electrical resistivity. On the other hand, the final pass of pressed wire has both the best hardness dispersal uniformity and the highest electrical resistivity.