In this article, a new manufacturing method is introduced to shape circular tubes into columns with triangular cross-section by the elastoforming process. Also, a theoretical analysis is performed to derive a theoretical formula for predicting total dissipated energy that is required for the forming process. For this purpose, V-shape dies with different angles are designed and some aluminum and brazen tubes with different characteristics are prepared. The circular tubes in the empty and filled conditions are compressed between a rigid V-shape die and a flat punch, and during the plastic deformation under the lateral loading, the tubes are shaped into the triangular sections. Considering different tube lengths, outer diameters and wall thicknesses, the specimens are categorized. Also, some of the samples are filled by cylindrical polyethylene Teflon with different thicknesses to investigate the effects of Teflon-filler on the shaping process of the triangular columns. The experiments show that using the cylindrical Teflon-filler, deformation mode of the triangular tubes improves, significantly. In addition, experimental observations of the deformation modes illustrate that there is an optimum value for wall thickness of cylindrical Teflon-filler and the tubes with the optimum Teflon-filler forms close to desirable triangular shape. The results show that by increasing tube wall thickness, probability of crack initiation and fracture reduces. Furthermore, comparison of estimations by the presented theory and the corresponding experimental measurements show an acceptable agreement, in both of empty and filled conditions.